just get the extended ball joint ones if its legality your worried about
Extended ball joints will normally make the wheel alignment even worse. When we designed them for the Navara, they had to be installed with off set castor bushes.
are there castor correction bushes / pins available?
There are castor correction bushes available and they work incredibly well. Most vehicles only require the top control arm bushes but you can do the bottom as well. By decreasing the camber, you will increase the castor.
All the bushes we used are manufactured by SuperPro in QLD.
Top Control Arm KitSPF3230K-Inner Eccentric Kit =$290Contains- 4 Bushings, 4 Inner Tubes, 4 Washers, 1 Instruction Sheet
Special notes- Offset tube in kit for Camber Decrease on raised vehicles, Remove original shell for fitment
Lower Control Arm KitSPF3146K- INNER FRONT ECCENTRIC =$280Contains- 2 Bushings, 2 Inner Tubes, 2 Outer Shells, 4 Washers, 1 Instruction Sheet
Special Notes- 2 x Offset, aprox 0.6 degree camber change
SPF3147K- INNER REAR ECCENTRIC =$320Contains- 2 Bushings, 2 Inner Tubes, 2 Outer Shells, 4 Washers, 1 Instruction Sheet
Special notes- 2 x Offset bushings, aprox 0.6 degree camber change.