Its an 07 model, 2.7 vvti workmate tray back. Got it from the dealer with nudge bar, spotties, heavy duty tray, work light and the freebies (bonnet and headlight protectors and rubber floor mats). I changed the exhaust on it, to a no muffler system, ask Skog and the boys who went to Nyah how loud it was (had to take it off....too noisy apparently, damn EPA)
Here's what she looked like:
First thing to go on was the toolbox, then closely followed by the side steps, which originally were off a dual cab, but with the help of one of my mates, we cut them down to size. I also put a UHF in with aux speaker, 2 aerials and a aerial switch.
I always hated the grey bumper, so I managed to get a colour coded one for a slab from a Toyota dealer. Along with this bumper came the 11 clearance lights
I have made a few things to help with the tray set up, here is the jerry can holder and the moto wheel guides
I also made a little aluminum "bash plate" for it
Next along was the LED tail lights which I had to make new holders for, made replica's of the originals, and the 55w reverse light
Also have done a few other small things, like added air horns, brake controller, another 12v socket, new UHF with remote mic, etc etc and the most recent thing was adding another 19 clearance lights, pic below
Just dont lower it....
