Toytec Top Plate 1/2 " Spacer

[Hilux Max]

Guys,

Came across this and knew some of you may be interested.

It's a 1/2 inch metal strut spacer that goes ontop of your strut and gives you 3/4" more lift they say on the website below -
http://trdparts4u.com/PD-TOP1-T.aspx?MakeID=1


It comes with longer studs and is $60 US, not oo bad.

This is perfect for those of you that have a 2" lift that your happy with the performance and ride, but would want a little bit more height.....

edit: Just sent em an email to get a quote in aussie dollars.....may lift the lux a tad more on the front

[HiruxHijinx]

Yeah, sounds good, let us know the quote price when you get is Mmaaxx!!

Sam.

[Hilux Max]

just over 100bux shipped to melbourne...contact them direct, they accept international payments via paypal. so its all secure and above board.

[ripin5.0l]

let us know if u go ahead with this max... would be alright if u add a bar on the front n u lose sum height, u think this would get u sum height back??

[Hilux Max]

yeah, it would......3/4 of an inch.

im not gonna go ahead, my cv's are angled as far as they reasonably can be, cant go more than the full 3" i already got without causing problems as much as id love a taller hilux.

[ripin5.0l]

yeh i know where ur comin from.... but if i ever fit a bar 2 my rig i will be lookin up this thread again!

[Bull]

Is there enough room in a front Hilux shock to take an additional half inch of bump travel? Because that's what you'll get if the bumpstops remain the same.

[Hilux Max]

You'll have to modify/extend the bumpstops with any sort of block lift/spacer lift to the front end.....

it's even a good idea to check them and extend them slightly when fitting a coil over front suspension, just to protect the suspension so you bottom out on the bumpstop and your not bottoming out the strut in that one off hard landing that can happen.

[MADLUX81]

Apologies for the amateur question but, I have a 2011 sr with a 2" old man emu lift. I have been enjoying off-roading for years but have very limited knowledge on the technical side of things. So my question is, can I add 1" spacers to the front end without needing to do anything like extend brake lines or anything else to accommodate them?