by 9W6VX on Wed, 02 Jul 2008 3:50 +0000
The instructions are as follows:
***
Adjust the vertical headlight aim into the specified range by turning aiming screw (LOWER) with a screwdriver.
HINT:
1. Perform lo beam aim adjustment.
2. The headlight aim moves down when turning the aiming screw clockwise, and moves up when turning the aiming screw counterclockwise.
3. Adjust the aim vertically by turning the vertical aiming screw and the horizontal aiming screw at a 5:4 ratio (5 turns of the vertical aiming screw for 4 turns of the horizontal aiming screw).
NOTICE:
If the screw is tightened too much, loosen it and then retighten it so that the final turn of the screw is in the clockwise direction.
***
Adjust the horizontal headlight aim into the specified range by turning aiming screw (UPPER) with a screwdriver.
HINT:
Perform lo beam aim adjustment.
NOTICE:
If the screw is tightened too much, loosen it and then retighten it so that the final turn of the screw is in the clockwise direction.
Cheers
Brendon
73 de 9W6VX