Removing KOLO

Removing KOLO

Postby hilzee10 on Mon, 13 Jan 2020 9:35 +0000

So I'm on a mission to remove my RedArc KOLO. I read another post that mentioned taking out the fuse and I found mine that was connected to a switch. Guessing this was an overide? But out of the three terminals on the switch, only one was used, being the inline fuse. Cant find a wiring diagram for the switch, guessing a cheapie. I'd definetly prefer to remove the whole system. So how difficult is the removal process? I'm rather handy but I'd like to see if anyone else has. Does the KOLO's wiring loom go to the headlights, or are ther connecters under the dash that you can just unplug and change? Cheers guys :)
hilzee10
 
Posts: 4
Joined: Tue, 19 Nov 2019 8:42 +0000
Location: Lesmurdie, WA


 

Re: Removing KOLO

Postby johnwood on Tue, 14 Jan 2020 9:19 +0000

A one wire switch cant be doing much! If it is a redarc or ionnic unit it will Most likely be cable tied near the upper steering column, if done with relays a bit further in but trace wires back up steering column.
Its only a few screws to have a look removing plastic around column,
If you have basic tools and a soldering iron / heat shrink / tape it wont be hard to revert to factory wiring.
johnwood
 
Posts: 173
Joined: Wed, 06 Feb 2013 10:26 +0000

Re: Removing KOLO

Postby DeadlyBeast on Tue, 14 Jan 2020 11:48 +0000

Why do you want to remove it? Sounds like a handy device.
That switch you found may disable it.

https://www.redarc.com.au/Content/Images/uploaded/Manuals/KOLO%20Instruction%20Manual.pdf

You may find a good use for it down the track :?:
If you're going through hell, keep going.
________________________
2007 SR5 D4D Auto
2014 SR D4D Auto
Build Thread
User avatar
DeadlyBeast
Moderator
 
Posts: 1825
Joined: Sat, 26 May 2012 7:42 +0000
Location: Top End


Return to Electrical

Who is online

Users browsing this forum: No registered users and 0 guests