I'm looking at replacing the 3/4 bench seat in my workmate to a bucket seat from an SR model. I will also add a centre console as well.
I have 2013 dual cab, 4WD, manual, diesel.
I have searched the forum and the reply I found suggests that it will bolt straight in (after drilling through the pan to locate the factory bolts). However, I have measured the front bracket / bolt spacing (left to right) of my drivers seat and it differs from the spacing to the passenger bench seat.
Drivers - 430mm approx
Bench - 370mm approx
I currently can source a LH bucket seat from a 2013 SINGLE cab SR model from the wreckers but unable to find out the bracket / bolt spacing on it.
Can anyone shed some light on this, any help is greatly appreciated