So this morning she went off to OL to get the drawers in. Very happy with the end result.
Took the measurements again for the rear, the bum's dropped 14mm from 765 to 751 - So they must be pretty heavy! I'm getting a 2" lift sorted atm, which should be an early birthday present sometime in march/early april - which carry the load better and whatnot so I'm pretty stoked for the next couple of pay packets!
Before
After
It's got the fridge slide as well but the camera ran out of go-juice.
I'm tossing up where to mount the compressor. For ease of access, I'm thinking of mounting it like the picture below, but for long term, and keeping as much packing space on top I'm thinking of putting it down in the cubby hole you can see near the mudguard, out of sight, but still easy to access. Not sure, but leaning to the cubby hole as it hides it away from prying eyes, and keeps more packing space on top of the drawers should I ever need it.
Up the front of the of the tray there's about 150mm or so (haven't measured) that's unused which you can't access without taking screws out. I'm going to get a hole saw and put a finger hole in each of these so I can put the stuff I hope I dont have to access on a trip like radiator hoses etc in there, without the need to have the screws holding it in.
That's all for the moment, just the diff breathers (hi Mark), lift (hi Brendon) n sliders/steps (hi Buddy) to go
Whitey