Talktheroo wrote:One of the best parts crews in Brisbane is Jerry's team.
This is Oldmac Toyota at Cleveland.
The Roo.
Talktheroo wrote:Yep, you save big time by installing a new water pump at the same time. It's done and dusted, then.
With genuine parts, anything from $1,100 to $1,500. Remember, quality workmanship cost a bit more. Some people will say you don't need to do the camshaft seal, but I have seen them leak around the 200,000 to 250,000km mark. So, are you going to go back in there again, just to replace something that could of been easily replaced at the 150,000km service. It's called false economy like how most of the political class speak.
The Roo.
rory18 wrote:I just used the old belt wrapped around the cam pulley and a pair of vice grips to hold it tight than undid the bolt with a socket and breaker bar. If you can get a hold of a mate with a rattle gun it makes it easier. and to get the cam gear off just give it a tap around the center and it will pop straight off.
Users browsing this forum: No registered users and 15 guests