Evo...from my post above mate....
ATTENTION guys n gals....EXCITING & NEW INFORMATION....IMPORTANT !
Up to now, anyone with ONLY a "G" chip VALET key ( from Sept '09 onwards ) could not get a copy OR a remote key without pulling the dash out of the vehicle to get to the immobiliser unit and then having it eepromed - ( virginised ) and then new master chips written into it...OUR Cost $1,500.....Toyota, $2,500 upwards.
New technology has JUST arrived and now "G" chip VALET keys can be CLONED....with or without the intergrated Keyless Entry function
Of course the Keyless Entry still has to be programmed to the vehicle via on-board programming which anyone can do themselves....BUT, the chip itself is ready to START and run the vehicle.
Please feel free to pm me for more information.
********************************************************************************************************************************************
Dirty.....here are the instructions for programming the remote portion...
1: sit in car with door open
2: insert new key in ignition and remove it TWICE
2: close and open drivers door twice ending up with door open
3: insert key in ignition and remove it ONCE
4: close and open drivers door twice - then CLOSE it.
5: put key in ignition and turn to full dash light for 2 seconds....remove key and the door locks will lock/unlock indicating you are in programming mode
6: hold BOTH lock & unlock buttons together for 2 seconds then press LOCK button for 2 seconds...doors locks will lock & unlock again. remote is now programmed.
IF the door locks lock & unlock TWICE....repeat step 6 again...it is still in programming mode as this stage.
You do not have to program any other working remotes back in....this is for ADDING a new remote.
Cheers, Ray.