TRDLuxxy wrote:John I need your help! Having brake issues. Now the vehicle brakes fine its just when I stop at an intersection or lights the pedal is spongy and sinks to the floor, when the vehicle is off the brake pedal feels rock hard which is what I prefer. I have gone over bleeding the brakes numerous times and zero bubbles are present, check valve is fine and creating vaccum have taken the master cylinder off and checked seals which are fine.
Do you know the correct brake booster pushrod length? If you measure the tip with a steel ruler to the flat surface of the booster where the master cylinder mounts too what is it? I know the workshop manual says 0mm but thats with an SST.
2012 SR non VSC, 25000km
150 series Prado brake calipers
DBA T3 4x4 338x35 rotors
QFM HPX pads
Braided brake lines
Vehicle off
https://youtu.be/xel_ybuzpDI
Vehicle on
https://youtu.be/fLXTKknQCBA
I'm about to wave the white flag and see a brake mob, thanks.
jaybags wrote:How does it handle offroad with that setup now?
Users browsing this forum: No registered users and 5 guests