GazaShaggy wrote:If the IPF wiring loom is the same as the Narva (Both have same dodgy mouse switch) then I have bad news I tried that the first time I wired my spotties but unfortunately no matter what I tried I couldn't get their loom to work with any other switch (I tried a couple)
Gsxr1000testpilot wrote:Can anyone spot the problem in figure 2 wiring diagram, or is it just me. This diagram is straight off there web site. I have bought the new led illuminated switches from customrockers, which adds another drama when wiring up your spotlights and trying to get the switch illumination working when the switch is on. Maybe I'm missing something . I have seen a few people have had trouble getting the switch illumination working to indicate the switch is on, which is easily fixed, but when it comes to these new led illuminated switches the polarity of the led becomes a issue as well, in the diagram they have fixed the problem of getting the led to light up but have put the circuits load through the switch. I THINK . Am I reading this wrong or is there a major error in there wiring diagram???
quinny525 wrote:Gsxr1000testpilot wrote:Can anyone spot the problem in figure 2 wiring diagram, or is it just me. This diagram is straight off there web site. I have bought the new led illuminated switches from customrockers, which adds another drama when wiring up your spotlights and trying to get the switch illumination working when the switch is on. Maybe I'm missing something . I have seen a few people have had trouble getting the switch illumination working to indicate the switch is on, which is easily fixed, but when it comes to these new led illuminated switches the polarity of the led becomes a issue as well, in the diagram they have fixed the problem of getting the led to light up but have put the circuits load through the switch. I THINK . Am I reading this wrong or is there a major error in there wiring diagram???
has anyone brought a CR switch lately and installed to the diagram that is now on the CR website??
Looking at this one that people have been having trouble with and the new one on there site is now different.
i just ordered a couple last night and like to know before starting to wire this way.
cheers
quinny525 wrote:It's on the first page of this thread and also on another that is linked to here too. The one on Custom rockers site shows pin 8 from switch connected to the High beam circuit that turns negative when switched on and also pin 86 goes to the same place.
I had been reading on and off for weeks before I brought my LED bar light from Newtech Pro and the switch from CR. Should be turning up tomorrow so was just hoping someone may have used the new diagram with success as their was posts for using a diode and another for using a second relay....
Users browsing this forum: No registered users and 25 guests