MLTZER wrote:nice, love the voltmeter setup. I may have to steal that idea.
blkrota wrote:Very tidy mate, the only thing that is stopping it from being flawless is the crushed side step , no big deal, but im guessing you will change them soon hey?.
Realy like the tray and tool box setup. so clean.
blkrota wrote:You going the open sliders or with the plate section?.
Iv seen some of the damaged factory steps can do to the ute as they are like butter, hence me taking them off untill we finish mine or make up my mind to go with Buds. Its a gamble without'em, the extra clearance has got me through some sections. Oh and it looks better without them.
The luck will run out soon though
qldminer wrote:Where did you buy the rubber mat in the back from.?, how much did it cost.
GazaShaggy wrote:blkrota wrote:You going the open sliders or with the plate section?.
Iv seen some of the damaged factory steps can do to the ute as they are like butter, hence me taking them off untill we finish mine or make up my mind to go with Buds. Its a gamble without'em, the extra clearance has got me through some sections. Oh and it looks better without them.
The luck will run out soon though
I like the look of the ones with the black checker plate I was thinking of doing my own as well but without a notcher I think it will be a long boring job plus trying to get the mounts all correct I decided its just easier to get the Buds ones
blkrota wrote:GazaShaggy wrote:blkrota wrote:You going the open sliders or with the plate section?.
Iv seen some of the damaged factory steps can do to the ute as they are like butter, hence me taking them off untill we finish mine or make up my mind to go with Buds. Its a gamble without'em, the extra clearance has got me through some sections. Oh and it looks better without them.
The luck will run out soon though
I like the look of the ones with the black checker plate I was thinking of doing my own as well but without a notcher I think it will be a long boring job plus trying to get the mounts all correct I decided its just easier to get the Buds ones
Cool, same here, tho i was leaning towards the flat plate slidders and put some marine tape for some grip.
It is heaps cheaper to build your own,,, but,,,
Yea , we have a notcher and its still a decent job getting all the angles rite. We have only done the sliders and two brakets. Its all just primered up so it doesnt rust. Sad to see it all just sitting there.
Easty270 wrote:Hey man did you end up taking your lightbar off?
I have one on the bar aswell and nowhere else to
Put it without a fair bit of cutting and welding..
Trucks looks good to bet that big tray is handy.
sbeelitz_02 wrote:How did you attach the lights under your bonnet? Have you had any trouble with them with the heat under the bonnet?
Users browsing this forum: No registered users and 56 guests