lais817 wrote:No mate, you're on the money, if you want to have the led light up on the switch using the bottom diagram (and the ONLY way, as far as I can work out) is to have a second relay between pin# 3 on the switch and the spotlights, ie
Pin 85 2nd relay -> Wire from pin# 3
Pin 86 2nd Relay -> Earth
Pin 30 2nd relay -> 12v +
Pin 87 2nd Relay - Output to spotlights
Unless anybody else out there has a better idea, when I tidy my wiring under the bonnet in the next few weeks this is how I will be doing it.
10 luxxxx wrote:Does anyone have a wiring diagram or know what each of the wires coming out of the back of the rear demister button are. I'm trying to change it for a custom rocker and have no idea.
Cheers.
junga23 wrote:10 luxxxx wrote:Does anyone have a wiring diagram or know what each of the wires coming out of the back of the rear demister button are. I'm trying to change it for a custom rocker and have no idea.
Cheers.
Did ya end up getting this fitted mate i did mine last week if ya need to know what goes where
lais817 wrote:
That looks a bit neater than the way I was thinking mate, how would be the best way to put the diodes into the circuit? Could you use this sort of thing
http://item.mobileweb.ebay.com.au/viewi ... 0631627297
10 luxxxx wrote:junga23 wrote:10 luxxxx wrote:Does anyone have a wiring diagram or know what each of the wires coming out of the back of the rear demister button are. I'm trying to change it for a custom rocker and have no idea.
Cheers.
Did ya end up getting this fitted mate i did mine last week if ya need to know what goes where
I haven't yet mate if you could share what you have done that would be great.
Bob E Dazzla wrote:Aaaahhhhh
I have a 2012 SR and had driving lights and IPF spotlights installed by ARB. I saved my money and purchased two Custom Rocker switches to replace the dodgy 'mouse' switches that come with IPFs. I furgured it would be quite simple given that the relays and switches already work but .... no
I have a dash light positive sorted
Spotlights:
There are three wire off into the IPF switch - one is always positive, one is positive when the lights are off and the other is negative.
Does anyone know how to wire this to the CR switch? I know that I could start from scractch and rewire the lot following the diagrams so helpfully provided but I realy don't have the time to pull everything out and I hope that I don't have to.
Users browsing this forum: No registered users and 22 guests