Picked up the rack on Friday and fitted it today, great rack... (
). Ended up getting the Rhino tracks which are vehicle specific and fit in the rain channels on the roof. Drilled the holes, rust protected with zinc-it, then put some black silicon in the holes and riveted the track down. Also put some silicon on top of the rivets to be sure.
Only problem was the little alloy blocks that slide back and forth inside the track and retain the nuts that hold the rack down... They only fit in one way and stick up about 10mm above the track. The rack feet sit on top of these and bolt to them, but it's not right, because the feet don't contact the track and so don't bolt down against it. Theoretically the whole rack should move fore and aft, but it's rock solid for now, not sure why. Obviously the two products are not compatible, but it works until I find the solution during the week. Rhino feet must have some sort of spacer that fits around the block.
Aside from that, very happy with the setup. The tracks are flush with the roof and very neat. The rack is low profile, solid, well designed and makes almost no wind noise at all!
Oh and I ended up getting the bigger rack, dimensions are 1230 wide and 1550 long. You can see in the pics below that it is the perfect size for the dual cab roof.
Looks great, low profile:
As big as you could fit on a dual cab without hanging out front or back:
Front:
Back:
Track looks like it's factory. You can also see in this pic the two little alloy blocks that the feet sit on... It's not right, needs a spacer of some sort: