Phat Bar bash plate with ARB cut out
Posted: Sun, 29 Jan 2017 9:01 +0000Hi Guys
i just received my bash guard and sump plate on Friday and finally got to install it this afternoon - well the bash plate anyway
they are quite solid being 5mm thick
here are some pics - click them for full size
one thing im not sure about is the hole size, it is quite rectangular and not circular which leaves some room for some play. you obviously have to use washers but the wholes are quite bigger than the factory bash plate holes - when you are tightening the nut the washers begin to bend into the hole
i was not able to install the factory plastic rock guard between the bumper and radiator cross member after bash plate is installed. im not sure if this would be an issue?
i just received my bash guard and sump plate on Friday and finally got to install it this afternoon - well the bash plate anyway
they are quite solid being 5mm thick
here are some pics - click them for full size
one thing im not sure about is the hole size, it is quite rectangular and not circular which leaves some room for some play. you obviously have to use washers but the wholes are quite bigger than the factory bash plate holes - when you are tightening the nut the washers begin to bend into the hole
i was not able to install the factory plastic rock guard between the bumper and radiator cross member after bash plate is installed. im not sure if this would be an issue?