Phat Bar bash plate with ARB cut out

[krayzie]

Hi Guys

i just received my bash guard and sump plate on Friday and finally got to install it this afternoon - well the bash plate anyway

they are quite solid being 5mm thick

here are some pics - click them for full size






one thing im not sure about is the hole size, it is quite rectangular and not circular which leaves some room for some play. you obviously have to use washers but the wholes are quite bigger than the factory bash plate holes - when you are tightening the nut the washers begin to bend into the hole

i was not able to install the factory plastic rock guard between the bumper and radiator cross member after bash plate is installed. im not sure if this would be an issue?

[Marsh]

Looks good, I'm planning on ordering the same thing. Was it straight forward to install yourself?

[krayzie]

yeah it was. remove the plastic rock guard and then remove the factory bash plate then the radiator bracket

bolt the recovery point and then the bash plate and your done