Modifying a non winch bullbar to suit a winch

Bull bars, sliders, wheel carriers etc!

Re: Modifying a non winch bullbar to suit a winch

Postby mf_shifty on Sun, 20 Jul 2014 5:04 +0000

Wiring in a Tigerz11 Grande winch, into your cabin / in car

So i searched as best i could to find how to wire my winch into the car as piggy backing the main three wires just didnt work, i was thrown off alittle when you see 4 wires leave the solinode block to the plug on the front, but when you open up the hand controlled you see it only uses 3 wires, a constant and two others (im not an electrician) so as i said i focused on the the three centre wires for far to long to finally figure out the black one wasnt nessisary and the red one is your constant. hope my picture helps, ive done my best to illistrate the solinoid, the standard remote plug and the Momentary switch i bought off ebay.

Image
mf_shifty
 
Posts: 53
Joined: Thu, 27 Mar 2014 5:09 +0000


 

Re: Modifying a non winch bullbar to suit a winch

Postby Terror on Thu, 19 Apr 2018 1:25 +0000

Thanks for the write up on this, it was a long time ago so I don't know if you are still active, but have you used the winch yet? and did it rip your bar off? :lol:

Thinking about doing the same to my ARB deluxe non winch bar on my 2012 Hilux. Can't justify $2400 for a new one when I already have one.
User avatar
Terror
 
Posts: 60
Joined: Sun, 31 Jan 2016 8:48 +0000
Location: Sydney

Previous

Return to Exterior Mods

Who is online

Users browsing this forum: No registered users and 7 guests