NewHilux.net

I found a sheet of stainless steel laying around the house so i thought id design and make my own bash plate. Took me a few hours of work after i got it bent into shape. Its made from 3.5mm stainless steel. Whats everyone think?

Not bad mate

That is pritty sick , good work,

you gona paint it?

good stuff mate.

Nice work!

Now you just need one to protect the front of that radiator.

Looks good! What,s the rectangular hole with the fold along one side for?

Looks good! What,s the rectangular hole with the fold along one side for?

Top workmate, looks neat

Thanks Guys

blkrota wrote:That is pritty sick , good work,

you gona paint it?

I dont think i will for now mate, if i get time i mite go over it with a wire brush to get rid of some marks, but it is stainless steel so corrosion shouldnt be an issue.

cooganstein wrote:Looks good! What,s the rectangular hole with the fold along one side for?

The rectangular hole is to so i don't have to take it off when i change the oil, the fold is for so when it skids along sand/mud it wont scoop up as much crap up there as it would if it was a straight edge that's the idea anyways

Looks good mate. Beats the crappy standard ones..

I like that. gotta service mine in couple a hundred k,s so i,ll b adding that service point and save me some time in the future.

Probably could help stop a bit of suction if sitting in the mud too.

I like that. gotta service mine in couple a hundred k,s so i,ll b adding that service point and save me some time in the future.

Probably could help stop a bit of suction if sitting in the mud too.

Looks good mate, the hole is a good idea with the flap bent up.



Lee.

Looks good mate. What’d you use to bend the plate? Also how thick did you make it?


Sent from my iPhone using Tapatalk