single keyway in 2.8 3l crank instead of 2x woodruff key
3 posts
• Page 1 of 1
single keyway in 2.8 3l crank instead of 2x woodruff key
by john253a on Thu, 23 Jan 2014 7:43 +0000
anyone ever removed the 2 woodruff key (r10 x 6mm) and replace it with a 6x10mm key running the full length of the crank shaft?
farting is alot like jxxxxxg off. both provide instant gratification, but neither is a long term solution to the actual problem......................
- john253a
- Posts: 949
- Joined: Sat, 23 Oct 2010 10:10 +0000
- Location: vic
Re: single keyway in 2.8 3l crank instead of 2x woodruff key
by Cal.dunbar on Fri, 24 Jan 2014 5:22 +0000
nope. But i reckon nissan wished they had 2 on the 3litre patrol motor. i pulled a crank out of one at work. Key way sheered off. fig the crank and the pulley
- Cal.dunbar
- Posts: 63
- Joined: Sun, 22 Sep 2013 1:23 +0000
Re: single keyway in 2.8 3l crank instead of 2x woodruff key
by john253a on Fri, 24 Jan 2014 6:38 +0000
That's the only down side I see is that when it goes there's next to no repairing it
But I'm hine site it should go like they do now as it will have full coverage on the balance and held in by the timing gear to stop it shearing
But I'm hine site it should go like they do now as it will have full coverage on the balance and held in by the timing gear to stop it shearing
farting is alot like jxxxxxg off. both provide instant gratification, but neither is a long term solution to the actual problem......................
- john253a
- Posts: 949
- Joined: Sat, 23 Oct 2010 10:10 +0000
- Location: vic
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests
