loose wiring

General discussion of basically anything Hilux related

loose wiring

Postby IliasBayler on Wed, 27 Mar 2024 5:22 +0000

hi ive got a loose contact( i think its called) it runs from the battery and splits off into two wires one small one to the starter and then the big loose one. does anyone know where this goes, cheers
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti


 

Re: loose wiring

Postby ptommo59 on Wed, 27 Mar 2024 9:33 +0000

If you post a picture it will be easier to identify what you are talking about and where it should go.
ptommo59
 
Posts: 70
Joined: Mon, 20 Jul 2020 12:23 +0000
Location: Wodonga, Victoria

Re: loose wiring

Postby IliasBayler on Wed, 27 Mar 2024 9:48 +0000

yep sorry will upload it in about 40 min when im home cheers
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby IliasBayler on Wed, 27 Mar 2024 10:30 +0000

ptommo59 wrote:If you post a picture it will be easier to identify what you are talking about and where it should go.

https://gyazo.com/1168bbaba9215bfe090ab1f68f555170
bit hard to see but hopefully you can see where it splits off from the starter
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby Rob_Wood on Wed, 27 Mar 2024 12:32 +0000

Looks like the cable going to the starter motor, but difficult to see in this pic. Did you disconnect it or was it already flapping loose like this? Do you have an Anderson Plug somewhere? Just a couple of thoughts that might mean you don't have to climb underneath to trace it out.
Rob_Wood
 
Posts: 883
Joined: Mon, 21 Sep 2020 8:32 +0000
Location: NSW

Re: loose wiring

Postby IliasBayler on Wed, 27 Mar 2024 6:03 +0000

Rob_Wood wrote:Looks like the cable going to the starter motor, but difficult to see in this pic. Did you disconnect it or was it already flapping loose like this? Do you have an Anderson Plug somewhere? Just a couple of thoughts that might mean you don't have to climb underneath to trace it out.


Im 99% sure i disconnected it when removing the manifold or egr it must have been in the way, it goes from the battery to the starter. I cant see an anderson plug anywhere. Would i not just be able to cross match with another hilux? wasnt able to see any pictures or videos of what im after online.
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby Rob_Wood on Wed, 27 Mar 2024 6:13 +0000

If you have disconnected it, then you know where to reconnect it. Just make sure you put it back where it came from.
If you can't remember, then yeah, cross-reference it with another Hilux. If you want to check online, like on YouTube or something, then I'd suggest watching 50 to 100 clips before making a decision. After a while you'll start to see a pattern of informative clips and a pattern of complete dills. You can then decide which pattern to follow.
Rob_Wood
 
Posts: 883
Joined: Mon, 21 Sep 2020 8:32 +0000
Location: NSW

Re: loose wiring

Postby ptommo59 on Thu, 28 Mar 2024 8:13 +0000

Sorry still cant make out from the photo.

Is it from the positive or negative battery terminal and then splits into the two?

If the positive side, the heavy gauge black one should go to the starter motor and the lighter gauge white one goes to the fuse box terminal 1A (on the underside of the fuse box?) which should be connected to the fusible link area and one side of several of the larger Amp fuses.

If its the cable for the negative side of battery then one goes to the engine earth point (may need to confirm but I think is a bolt at the rear of the head or could be lower on the engine block) and the other to the mudguard/body earth point beside the battery.
ptommo59
 
Posts: 70
Joined: Mon, 20 Jul 2020 12:23 +0000
Location: Wodonga, Victoria

Re: loose wiring

Postby IliasBayler on Thu, 28 Mar 2024 4:36 +0000

ptommo59 wrote:Sorry still cant make out from the photo.

Is it from the positive or negative battery terminal and then splits into the two?

If the positive side, the heavy gauge black one should go to the starter motor and the lighter gauge white one goes to the fuse box terminal 1A (on the underside of the fuse box?) which should be connected to the fusible link area and one side of several of the larger Amp fuses.

If its the cable for the negative side of battery then one goes to the engine earth point (may need to confirm but I think is a bolt at the rear of the head or could be lower on the engine block) and the other to the mudguard/body earth point beside the battery.

your a legend mate thanks very much I will take a look tomorrow thanks again
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby Philos on Fri, 29 Mar 2024 4:48 +0000

Whatever it is, it's quite badly corroded. While you've got it free and easy, give a spray with some sort of anticorrosion spray. Joints like that are only a matter of time before they give you grief.
Philos
 
Posts: 48
Joined: Thu, 16 Jul 2020 11:00 +0000
Location: Yeppoon, Qld

Re: loose wiring

Postby IliasBayler on Fri, 29 Mar 2024 6:38 +0000

ptommo59 wrote:Sorry still cant make out from the photo.

Is it from the positive or negative battery terminal and then splits into the two?

If the positive side, the heavy gauge black one should go to the starter motor and the lighter gauge white one goes to the fuse box terminal 1A (on the underside of the fuse box?) which should be connected to the fusible link area and one side of several of the larger Amp fuses.

If its the cable for the negative side of battery then one goes to the engine earth point (may need to confirm but I think is a bolt at the rear of the head or could be lower on the engine block) and the other to the mudguard/body earth point beside the battery.

hey so double checked , theres a small black one going to the netagive terminal and a bigger black one going to positve then a smaller one goes to the starter motor and then the bigger ones loose. the loose big wire also has a smaller one next to it that bolts on to the chassis . sorry i cant explain it better. thanks.


https://gyazo.com/4022cb69f6c599d744b6ffb6c514fda9

https://gyazo.com/1f574cf80e57a01055a2b69addb392b3

https://gyazo.com/89c0c5d19060256a2dda78866fb56c99
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby IliasBayler on Fri, 29 Mar 2024 6:38 +0000

Philos wrote:Whatever it is, it's quite badly corroded. While you've got it free and easy, give a spray with some sort of anticorrosion spray. Joints like that are only a matter of time before they give you grief.

will do thanks
IliasBayler
 
Posts: 17
Joined: Fri, 16 Feb 2024 6:53 +0000
Location: new zealand kapiti

Re: loose wiring

Postby Rob_Wood on Fri, 29 Mar 2024 11:18 +0000

I'd "GUESS" (I am only guessing) that it's either the engine main negative or the starter main positive.
Get it wrong and you'll have big problems.
I'd suggest trace it back and find where the other end of this cable goes to, this will help you identify it more easily.
Rob_Wood
 
Posts: 883
Joined: Mon, 21 Sep 2020 8:32 +0000
Location: NSW


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 27 guests