Rear wheel bearings in ln167

[Bra89y]

Hey guys I have to do my rear wheel bearings in my ln167 im just wondering if the bearings have to be pressed in and out?? Or if I would be about do them my self?

[toyboata]

You can dismantle the bearings after removing axles, leaving just the inner bearing race, then cut through the bearing race with an angle grinder, careful not to cut into the axle. This can then be chiseled off with air chisel or by hand with cold chisel or something similar.
The new bearings however will need to be pressed on with a shop press.

[Bra89y]

You can dismantle the bearings after removing axles, leaving just the inner bearing race, then cut through the bearing race with an angle grinder, careful not to cut into the axle. This can then be chiseled off with air chisel or by hand with cold chisel or something similar.
The new bearings however will need to be pressed on with a shop press.

thank u for that i might just pull my axles out and thank them somewhere to get them to pull them out and than put new ones in