Page 1 of 1

ARB compressor under bonnet install

PostPosted: Tue, 23 Jul 2013 10:18 +0000
by Zaxusername
Hi guys
I'm new to this forum, but so far have found so much info.....that said, can someone share their experience of fitting a ARB compressor under the hood of a kzn165. There aren't many choices but it would be good to see others perspectives.
Apologies if this topic has been done to death.

Re: ARB compressor under bonnet install

PostPosted: Wed, 24 Jul 2013 9:30 +0000
by Zaxusername
I.ve read plenty of posts here about on board air and receiver tanks for inflating tyres but no info on the compressor install.
I have a 2004 dual cab with the 1 kz-te, surely someone's got the same or similar vehicle who has had to tackle this ;)

Re: ARB compressor under bonnet install

PostPosted: Wed, 24 Jul 2013 10:12 +0000
by TDog
Check my build thread mate. And welcome to the forum!

Not a lot for us older Lux guys here but there are a few.

Re: ARB compressor under bonnet install

PostPosted: Tue, 29 Oct 2013 9:22 +0000
by csale
Zaxusername wrote:I.ve read plenty of posts here about on board air and receiver tanks for inflating tyres but no info on the compressor install.
I have a 2004 dual cab with the 1 kz-te, surely someone's got the same or similar vehicle who has had to tackle this ;)


I mounted my Viair compressor under the bed behind the rear mudflap. Viair says don't mount upside down but knock on wood no issued in 4 years.