Heya folks!
It's been far too long since my last post, and its been far too quiet on the site IMO!
I'm ready to do a 3" exhaust from the dump straight through; and need some advice RE the placement of the exhaust tip. I dont care for looks at all, just practicality.
See photos below of my current (stock) exhaust tip, note the routing and how it is rubbing on my 33" spare tyre. Any suggestions on how to route a 3" exhaust at this section of the vehicle? Can it go above the spring close to the chassis rail? Can it be routed any differently at all?
Please keep in mind that i carry an exhaust jack for recovery and it is necessary to reach the tip to use this tool.
I appreciate all ideas! I hope to get the exhaust custom welded up this coming Saturday. Cheers!