I Found them.
They are right besides the gear stick for each one of them. You need to pull out the console etc to get to them, Heres how.
1. Open the lid of your centre console, pull out all the crap and at the bottom there is 2 X 10mm bolts to remove
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6973.jpg)
2. Along the side of the console there are 4 screws (2 either side) remove them
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6971.jpg)
3. Unscrew gear knob, remove small philips screw in 4WD stick and lift panel up. When you have it up enough theres a wire for the 4WD button to disconnect before you can pull the panel/gear boots right off.
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6969.jpg)
4. Under this you will find two rubber boots around the gear sticks, on this panel is 4 gold 10mm bolts to remove, once undone get a small flat blade screw driver under one side of this plate and lift up. This will release it and make it easy to pull of. Then work the rubber boots up the sticks until completely free.
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6968.jpg)
5. Wallah, where you see the two blue hoses are the breathers. Now the issue is that they dont bolt on/off like the diff ones. So i popped off the top cap (same as diffs) and it has a small hole inside the breather. Luckily for me i bought the BRC quad breather kit and the hoses were NEARLY small enough to fit in them holes, i did shave the ends down so that i could push the hose in about an inch. Now the obvious downfall here is the fact that this isnt the right way to secure them so i had one option and that was to sikaflex them on, so i did and all is good.
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6963-1.jpg)
And for me the finished product is this
![Image](http://i239.photobucket.com/albums/ff262/jpathy/IMG_6981.jpg)