Re: Chaps 2008 D4D SR5 build
Posted: Sat, 12 Mar 2016 10:53 +0000Really nice looking lux
Page 3 of 3
Posted: Sat, 12 Mar 2016 10:53 +0000Re: Chaps 2008 D4D SR5 build
Posted: Sat, 12 Mar 2016 11:51 +0000Nice one mate! keep up the good work.
Re: Chaps 2008 D4D SR5 build
Posted: Sat, 12 Mar 2016 1:55 +0000rds_929 wrote:awsome thanks mate yeah that's where i got mine from pretty sure they're the same any chance you could get a few close up pics of how the recovery points are mounted ??
I looked back through my phone, i remember there was some difficulty now.
some pics below:
You see the bull bar bracket partially covers one of the mounting holes, i either drilled it out or used an angle grinder and cut out a small section so the bolt could go through.
You have to do up the top two bolts, then put the side bash plate in position and then the bottom bolt over the whole lot.
Re: Chaps 2008 D4D SR5 build
Posted: Mon, 14 Mar 2016 3:56 +0000legend thanks heaps mate really appreciate it
Re: Chaps 2008 D4D SR5 build
Posted: Mon, 14 Mar 2016 4:53 +0000Nice looking lux mate. Mammoth effort on the tray change over. I had to remove my Outback draws a few times and that was a big enough job. Good job!
Re: Chaps 2008 D4D SR5 build
Posted: Tue, 28 Mar 2017 4:40 +0000Nice build mate! Looking real neat, im about to install a ctek aswell, theres a temp senson which says it gets mounted to starter battery, have you just mounted yours to aux batt?
Re: Chaps 2008 D4D SR5 build
Posted: Tue, 28 Mar 2017 5:24 +0000Yep, just mounted it with the aux battery and all works beautifully.