Cuzo's Build - update - Custom Tray Build - 12 volt
Posted: Sun, 15 Jul 2012 3:52 +0000
Thought I would start been inspired by alot of you guys and knowledge is great,
First thing I did was construct some custom draws for the back, to hold the bits and pieces I need for work, but the set up is temporarily but is working for know, went away last week end and used them for all the camping crap and they did all right,
Need to click on the pic to see it all - not sure why it does this.
I didn't use runners or any thing fancy, I ask my kitchen guy if had any cover sheets and he gave six sheets that had melamine on both sides if you know this stuff its very slippery, so all i did was hit it with some silicone spray and they slide like a dream.
Yesterday my tires were ready so into Castle Hill I went and the fitted up new 16" ROH rims with KUMHO Rubber.
Had to remove the front mud flaps cuase it was scrapping but all good next month the lift kit is on the cards.
Before Shot
After
First thing I did was construct some custom draws for the back, to hold the bits and pieces I need for work, but the set up is temporarily but is working for know, went away last week end and used them for all the camping crap and they did all right,
Need to click on the pic to see it all - not sure why it does this.
I didn't use runners or any thing fancy, I ask my kitchen guy if had any cover sheets and he gave six sheets that had melamine on both sides if you know this stuff its very slippery, so all i did was hit it with some silicone spray and they slide like a dream.
Yesterday my tires were ready so into Castle Hill I went and the fitted up new 16" ROH rims with KUMHO Rubber.
Had to remove the front mud flaps cuase it was scrapping but all good next month the lift kit is on the cards.
Before Shot
After