yeah, going to bolt through the tray corners. will add some extra bracing just in case.
I'm still keen for the big trip, but it's hard to get much done when recruiters keep calling. Also, I'm currently short listed for a high profile role. If that comes through, then I'll be a wage slave for a while longer.
the canopy is still empty, but i'm putting together a light pine frame to hold 12 x 50L plastic boxes. that should be sufficient to hold all of our crap
took the truck to Ultimate yesterday, added a leaf to the rear and changed rear shocks to the big gas monotubes. very happy with the ride even tho it is empty
today was a visit to the auto sparky. removing the crap from the previous sparky and wiring up my new tail lights, light bars, UHF and dual battery.
also had 2 recruiters call! I didn't say no, but I did say I'm going away SOON unless I get an offer
framing in the canopy finish mud guards (add a bit of rubber so they're 100% legal) wire up the winch fit bash plates add some extra protection for the radiator (using plastic gutter guard) fit the awning
Which bash plates did you go for Craig. I've got a panelbeated set of Tjm ones that need to be re installed but I smashed the radiator supprt bracket and it doesn't fit anymore. Boatie, a mate of mine was supposed to leave for a trip out West today still had the dash off this morning when I rang him to check to see if his lightbar bracket that I made for him fitted...
well it's good to see I'm not the only one doing last minute jobs (or is that jobs at the last minute?)
I've had a full set of Bud's standard plates installed for some time, but I've recently installed the MR diff drop. So I need to install the plate (under engine) that goes with that (will only take 2 minutes). Interestingly, I had to grind a small amount out of the back/end of the bash plate because the diff drop brackets were in the way. Anyway, that is done and fitted up. I also have a sheet of 3mm checker (alloy) that I had made up to cover the gap between the Bud's flat plate bar and the radiator (does not block air, just stones). it still needs some minor modification to be able to fit
Looks good Craig Any tow bar or rear recovery point going on? or just full of confidence and not planning on getting stuck or more to the point, finding any stuck Pootrols to snatch out
Cheers Rod __________________________________________________________________________________________ Bitumen ...... another waste of public funds
You gonna chuck a water tank or something under the tray? Plenty of room under there, may as well use it. Put some pics of the car from further away so we can see the whole set up.
Chris, I'd like to lower the tray by 50mm and then fill the gap (around 225mm) with water and fuel tanks and maybe lift the spare. either way, further work is gonna have to wait till I get back.