What I have is a 2011 pre face light SR5
2 inch efs springs with lovells struts in the front and 2 inch reset stock leaves with lovells shocks in the back.
265/70/17 KM2's for shoes.
Arb Deluxe bar.
Got a few other little things such as skog's diff breathers, on board compressor, rhino liner, lights, radios etc etc.
Haven't really done much to it mechanically as being a 3rd year apprentice with 2 mortgages money doesn't come around too often for the old girl to get presents.
So hear is ma ute without the sports bar as I have just taken it off for plasti dipping.
I fitted up some 10W LED work lamps onto the sports bar aswell, I used some DT-2 connectors and some cat clips, then ran the harness down the tube and it then goes into the tub corner at the fron via another DT-2 (so the bar can be removed easily)
Plasti dipped the rear chrome step too for shits and giggles, not really sure what to think of it though with all the other bits still being chrome but none the less I was bored.
fitted up a light bar the other week which goes alright, I have a few of the big LED lights as seen in the middle which I will use 2 of to replace the 2 piss ant narva 175's which are as effective as a candle in a lit room. the centre one is not mounted, just there to show ya's what I was talking about.
Some photos of the switches in the cab for lights and compressor etc
Skog breathers that I got from Amitch
Compressor I have is an ARB CMK12 and I have mounted it up to where the winch would go (that I don't have). it has been working here for years now. after I air up 4 tyres she gets farking hot so it works well cause it get air flow and cools down quickly once you start driving again.
I am in the process of making a rack for the tub similar to what bud does, so once I get going with that i'll take some photos.
Also plenthy of other things to do and that have already been done that i'll post up some stuff about soon too.
what else are you going to do to it?
