Hi all,
I was doing the timing belt and water pump service on my 2014 3L Hilux. I thought that I had both timing pulleys aligned before removing the old belt. New belt installed however, when I was turning the engine by hand I was stupid and did so via the camshaft pulley similar to viewtopic.php?f=81&t=29361&p=436022#p436022
The pump pulley was still a part turn away from alignment with the crankshaft not turning more than a quarter turn in either direction so dont know how to align these again.
Is there a way I can fix this or have i busted valves etc inside the engine? Everything has been done by hand and I have not attempted to turn over via the ignition.