Just installed a new genuine filter and oring. Pumped up fine and idles fine but has a slow leak from the housing.
Took housing apart and the oring were in the correct place.
Any tips?
Filter housing won't seal
3 posts
• Page 1 of 1
Filter housing won't seal
by millsi on Sat, 10 Dec 2016 12:37 +0000
- millsi
- Posts: 140
- Joined: Wed, 25 May 2011 4:52 +0000
Re: Filter housing won't seal
by TOYZX on Sat, 10 Dec 2016 3:16 +0000
Did ya lube the oring when fitting? If not ya may have pinched it.
Sent from my SM-N920I using Tapatalk
Sent from my SM-N920I using Tapatalk
-
TOYZX - Moderator
- Posts: 2919
- Joined: Wed, 08 May 2013 7:58 +0000
Re: Filter housing won't seal
by Gipsy on Sun, 11 Dec 2016 8:52 +0000
Is the old o ring still in there?
Cheers Gipsy 
although I'm sure somebody will challenge that 
even Einstein wasn't certain of his theories.
My 2013 auto D4D DC SR5, prefilter, 3" exhaust and Chip with egt probe, stock SR5 rims with Toyo Open Country AT2 265/65R/17's
although I'm sure somebody will challenge that even Einstein wasn't certain of his theories.My 2013 auto D4D DC SR5, prefilter, 3" exhaust and Chip with egt probe, stock SR5 rims with Toyo Open Country AT2 265/65R/17's
- Gipsy
- Posts: 2148
- Joined: Tue, 07 May 2013 2:00 +0000
- Location: South Coast NSW and all over Oz
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 15 guests
