Have done it to mine guys. You can buy the end caps for the bullbar from toyota (the only issue is that because they are physically bigger you need to drill some new holes in the sides of the bar. And it's an absolute pain in the arse if the useless pricks supplied a template it would be soooo much easier.) As for the flarelets that fill the gap , they fit easy enough . The main issue is you have to buy the entire kit, which includes the complete bumper infill under the grill. All said though it does look way better than just flares.Pazz01 wrote:I'm in the same boat as you rusty and looking at them
I've seen a few fitted and there is a bit of a gap between the end of the flare and the plastic butt on the bullbar, that looked a bit dicky. I seen on the toyota website the SR with the factory bullbar has flares and they have a larger piece of plastic on the butt of the bullbar and a capping part on between the edge of the flare and the plastic.
http://www.toyota.com.au/hilux/accessories
Be interested to see if anyone has got the same set up.
Pazz
oggy wrote:Have done it to mine guys. You can buy the end caps for the bullbar from toyota (the only issue is that because they are physically bigger you need to drill some new holes in the sides of the bar. And it's an absolute pain in the arse if the useless pricks supplied a template it would be soooo much easier.) As for the flarelets that fill the gap , they fit easy enough . The main issue is you have to buy the entire kit, which includes the complete bumper infill under the grill. All said though it does look way better than just flares.Pazz01 wrote:I'm in the same boat as you rusty and looking at them
I've seen a few fitted and there is a bit of a gap between the end of the flare and the plastic butt on the bullbar, that looked a bit dicky. I seen on the toyota website the SR with the factory bullbar has flares and they have a larger piece of plastic on the butt of the bullbar and a capping part on between the edge of the flare and the plastic.
http://www.toyota.com.au/hilux/accessories
Be interested to see if anyone has got the same set up.
Pazz
pilko4x4 wrote:Hey guys im refitting some utemart flares to my 12 sr. Im having some trouble to get them to fit the front near the arb bar against the guard. When i sit the flare for as trial fit , they fit great but when i tighten the screws up the flares move out from the guard and leave a gap of about 10 mm. Has anyone got any tips for me. Fits great all the way fron sill to abot 200 mm from front then i springs open. Hoping to get them on tonight or the morning. Thanks
pilko4x4 wrote:Yeah i did. Ive rang leon about that just to make sure. I got some tips off him to fit them up and just cannot get them correct. Thought there might be some tricks on here. Thanks
Users browsing this forum: No registered users and 16 guests