NewHilux.net

Put the bullbar on last night but I wasn't happy with the minium gap achieved. On the right had side
I got 15mm but on the left it was around 25mm. I tried loosening both side and re aligning but the left side is the same. Anyone got any tips. The bar is a TJM t14 outback

just a little advice...make sure u leave some gap..maybe 15 to 20 cm gap cause the body will flex more than the bar ..if u know what i mean..

Yea it's just that in the manual 15mm and I achieved it on the right side
Looks good but the left looks very ugly

I'm only new to it all but is it possible to check the bullbar and mounting brackets to your bus for squareness... Either one could be out of square...