Put the bullbar on last night but I wasn't happy with the minium gap achieved. On the right had side
I got 15mm but on the left it was around 25mm. I tried loosening both side and re aligning but the left side is the same. Anyone got any tips. The bar is a TJM t14 outback
Bull bar / flare gap
4 posts
• Page 1 of 1
Bull bar / flare gap
by Rhodesy27 on Fri, 15 Apr 2011 8:48 +0000
-
Rhodesy27 - Posts: 96
- Joined: Sun, 16 Jan 2011 8:11 +0000
- Location: Cairns Qld
Re: Bull bar / flare gap
by wholehog on Fri, 15 Apr 2011 3:26 +0000
just a little advice...make sure u leave some gap..maybe 15 to 20 cm gap cause the body will flex more than the bar ..if u know what i mean.. 
-
wholehog - Posts: 345
- Joined: Fri, 23 Jul 2010 7:43 +0000
- Location: Central Coast N.S.W
Re: Bull bar / flare gap
by Rhodesy27 on Fri, 15 Apr 2011 3:49 +0000
Yea it's just that in the manual 15mm and I achieved it on the right side
Looks good but the left looks very ugly
Looks good but the left looks very ugly
-
Rhodesy27 - Posts: 96
- Joined: Sun, 16 Jan 2011 8:11 +0000
- Location: Cairns Qld
Re: Bull bar / flare gap
by jamesheadlam1 on Mon, 19 Aug 2013 2:10 +0000
I'm only new to it all but is it possible to check the bullbar and mounting brackets to your bus for squareness... Either one could be out of square...
- jamesheadlam1
- Posts: 7
- Joined: Mon, 22 Jul 2013 6:47 +0000
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest
