Page 1 of 1
Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Mon, 19 Dec 2016 6:09 +0000by Andyfive
I used these codes and they appear to work ok:
ATF
07E02182
046105820000
2808
00010001FFD8
torque convertor
07e02182
046105820000
3808
00010001ffd8
EGT
Txd o7dfo178
Rxf 054106780000
Rxd 3810
Mth 0001000affd8
DPF
TXD 07DF0178
RXF 032100000000
RXD 2010
MTH 0001000AFFD8
Re: Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Wed, 21 Dec 2016 5:27 +0000by numberplate
kewl , with those temps can you see when a DPF burn occurs?
Re: Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Wed, 21 Dec 2016 5:47 +0000by Andyfive
I assume so. The DPF got up to 620 degrees the other day, i assume it was doing a burn as the EGT was much lower at the time.
Re: Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Wed, 21 Dec 2016 8:31 +0000by numberplate
thanks for that. I had thought of wiring an LED across the no5 injector so would get an indication that burn was occuring. might end up getting a scanguage anyway.
Re: Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Sat, 27 May 2017 5:27 +0000by fark
Does anyone know if the IAT is before or after the intercooler? I can see the IAT on my Scangauge, but i think its basically reading the ambient temp. I was interested to see the temp after the intercooler to see how hot the air was.
Thanks for the codes too Andyfive Andyfive, they work nicely.
Re: Scangauge ATF/EGT/DPF and Torque Convertor Temp
Posted:
Thu, 11 Apr 2019 6:28 +0000by BourkeyRobin
DPF ACCUMULATION LEVEL
TDX 07E02138
RXF 032104780000
RXD 4008
MTH 000200010000
MANUAL REGEN COMMAND
COMMAND NO =0
3029060101