Does anyone have a list of x guages that work with a 2022 hilux for a scanguage? On my 2017 model I had a lot more than is listed on the scanguage website for the 2022 model. Silverfox
Thanks ptommo59. A lot of those x-guage codes work. With the turbo boost pressure gauges you have "value - 14.7 psi sea level". Is this an adjustment I need to make with the scanguage? On mine I'm seeing peaks around 29 ( not sure if it's lbs) which is around 10 lb (?) More than I got on my '17 model. Seams pretty high. Are your readings on boost similar? Silverfox
If you key in the Barometric Pressure codes you can get your local reading which in my case is 14.3 PSI and adjust the last 4 digits FF6D in the Boost reading to match using the table below. Its only 0.4 PSI so not really significant.
If you key in the Barometric Pressure codes you can get your local reading which in my case is 14.3 PSI and adjust the last 4 digits FF6D in the Boost reading to match using the table below. In my case Its only 0.4 PSI difference so not really significant.
The Boost reading is in PSI and you will see significantly higher readings with the 150 kw engine over the older 130 kw due to the larger turbo (which is how its making the extra power and torque).
I haven't really checked mine so will have a look to see if it peaks around similar value to yours.
I have put lots of updates on the Prado Jul 2021+ model scangauge codes here on Pradopoint https://www.pradopoint.com.au/forum/-15 ... -21-models. Most should also work on the 150kw version Hilux and any starting with 07DF01 should work on most post 2006 vehicles with OBDII connectors. Hope this is helpful to someone out there.
These should work but will need the formulas in the MTH column verified. So if anyone uses them and has access to Techstream or a Scantool can you cross check that the gauge is reading correct or close enough and provide feedback (as there is a limitation on the maths that you can do with the Scangauge MTH so some can be out by a small margin).