I'm looking at buying a high lift jack (not decided which make/model) and am wondering where/how to lift?
My SR has the standard side steps a Toyota tow bar and ARB poly smart bar.
Thanks,
Mark
Markdavo wrote:I'm looking at buying a high lift jack (not decided which make/model) and am wondering where/how to lift?
My SR has the standard side steps a Toyota tow bar and ARB poly smart bar.
Thanks,
Mark
William_Foster wrote:Ronny Dahl did a good video about the different options: https://youtu.be/T5I4gae00Ho
I have a Larzep Telescpopic Bottle Jack and two smaller bottle jacks that provide a range of options, in addition I have a Safe Jack Base Plate (Distributed by ProQuip in Australia) to make a lift a bit safer. Can highly recommend.
SafeJack and a few others do base plates for High Lift Jacks as well to make them a bit safer.
William_Foster wrote:Ronny Dahl did a good video about the different options: https://youtu.be/T5I4gae00Ho
I have a Larzep Telescpopic Bottle Jack and two smaller bottle jacks that provide a range of options, in addition I have a Safe Jack Base Plate (Distributed by ProQuip in Australia) to make a lift a bit safer. Can highly recommend.
SafeJack and a few others do base plates for High Lift Jacks as well to make them a bit safer.
William_Foster wrote:Mark, I have a AB40434 which is rated at 4.1 tonne and extends from 265mm (Closed) to 610mm (Extended Height). I am not sure whether that model is still available or has been replaced; I have had it since 2014 so there is probably something new.
I have a 2” inch lift as part of my GVM upgrade which is why I needed it, but I still carry the standard Toyota bottle jack and another bottle jack I got with my camper trailer to give me a range of options.
I think it was pretty expensive from memory, but at the time I got it there was nothing comparable that I could find on the market.
As previously discussed, I use the Safe Jack Base Plate which fits with all three of my bottles jacks.
Users browsing this forum: No registered users and 3 guests