First post here so apologises if I haven't gone about the right way to do this but could not find any relevant information to my problem so far.
I've recently installed a 2" body lift to my Hilux and have followed instructions as they've been written by VMN. I have found that when installing my steering shaft connection I have to lower the top section of the shaft to make it connect with the lower. However when I do this the rubber boot creases and the shaft no longer sits centred.
Is it possible that the cab has shifted forward when installing the body lift resulting in me needing to lower the top section?
https://imghostr.net/image/flhfj
https://imghostr.net/image/fl8TR
https://imghostr.net/image/fl0y6
https://imghostr.net/image/flx3O
https://imghostr.net/image/fl3u9
