Page 1 of 1

Removing KOLO

PostPosted: Mon, 13 Jan 2020 9:35 +0000
by hilzee10
So I'm on a mission to remove my RedArc KOLO. I read another post that mentioned taking out the fuse and I found mine that was connected to a switch. Guessing this was an overide? But out of the three terminals on the switch, only one was used, being the inline fuse. Cant find a wiring diagram for the switch, guessing a cheapie. I'd definetly prefer to remove the whole system. So how difficult is the removal process? I'm rather handy but I'd like to see if anyone else has. Does the KOLO's wiring loom go to the headlights, or are ther connecters under the dash that you can just unplug and change? Cheers guys :)

Re: Removing KOLO

PostPosted: Tue, 14 Jan 2020 9:19 +0000
by johnwood
A one wire switch cant be doing much! If it is a redarc or ionnic unit it will Most likely be cable tied near the upper steering column, if done with relays a bit further in but trace wires back up steering column.
Its only a few screws to have a look removing plastic around column,
If you have basic tools and a soldering iron / heat shrink / tape it wont be hard to revert to factory wiring.

Re: Removing KOLO

PostPosted: Tue, 14 Jan 2020 11:48 +0000
by DeadlyBeast
Why do you want to remove it? Sounds like a handy device.
That switch you found may disable it.

https://www.redarc.com.au/Content/Images/uploaded/Manuals/KOLO%20Instruction%20Manual.pdf

You may find a good use for it down the track :?: