Hi guys I have a thread up about my abs I rectified the open circuit to both RR a RL speed sensor I hooked it up to techstream cleared code and it stays off then I drive about 20 Meters abs light comes back on Hook it back up to techstream keeps on coming up rh speed censor circuit with a little frozen sign next to it , continuity is good at the ba2 connecter to the back sensor I cleaned and rings as they were dirty The freeze sign worries me is it stored can I erase it Always does the same thing goes off and stays off and 20 Meters down the road comes back on Any help will be greatly appreciated I know I'm close but not close enough I know my drum pads are low on the r hand side but surely it's not that there's no sensors or nothing for that and the light comes back on before I even brake
*** Changed rear pads no good
Last edited by Morksvigo05 on Tue, 26 Jun 2018 11:23 +0000, edited 1 time in total.
Is it possible I'm getting good continuity whilst stationary even when I spin wheel by hand it's like when I get to about 20 30 K while under way it comes back on Like start checks fine etc Should mention it's a new sensor old wire
Fixed it guys I ground down the face of which the sensor seats on the actual diff itself had all rust and stuff Filed down the actual plastic of the sensor that seats on the face I ground and whalla done abs light cleared and stayed cleared so happy