by Malted on Wed, 24 Sep 2014 5:38 +0000
Time for some honesty.
I am unlikely to attend the expo next year, it was overpriced and had little content.
I received my canvas seat covers today for my SR non-airbag 05+ dualcab. I had high expectations after having seen the seat covers at the expo. I am somewhat underwhelmed. I wouldn't call them a SupaFit, I would call them a reasonable fit. I would say that they fit better than the dark waterfowl canvas covers on the work ute but I guess I was expecting some wow factor. Without being too critical, I might offer a suggestion.
The front seats, bottom section: the loop tape from the front that passes underneath to the rear, it seemed to be too long and up the wrong way. I doubled the end of the tape over so that it would stick to the carpet section of the seat and then also provide a section of hook for the loop velcro to attach the tongue of the canvas that pokes through between the upper and lower seat sections. I thought it might have been better if the tongue had hook on it instead of loop, in this way the whole tongue could fasten to the carpet of the seat rather than just to the tape and the two side tongues. Why not velcro loop on the side tongues, tape up the other way and velcro hook on the tongue that pokes between the seat sections? This way they are fastening to each other as well as to the seat (i.e. the wide tongue has a much wider fastening across its entire width along the carpet).
I am sure I would have other suggestions but the stuff above jumped out at me the most.
If it aint half off, it aint on sale!