If your running 285/75r16
The min max rim is 7.5-9" but recomenend is 8"
http://m.bfgoodrichtires.com/tire-selec ... c-pdf.page?
This is from the bfg site if you look at each size tyre it will give a min/max tyre size then the caluated with on set size (8" for 285/75r16) and then an overal size
Before you buy anything you need to know what offset you have now factory is p30
If you are running a 16x7 in p30 offset (factory)
That means that (7"x25.4=178mm) from the outside surface of rim to where the hub site is
178/2= centre+30mm=
60mm outside to flange
118mm inside outer edge to flange
So measure what you have now,
If you were to fit 16x8 with same p30 off set yes the rim will go out wider on each side but tyre will still site where it is now,
So if you want a wider stance buy 1" then you will new to order 25mm less offset then you have now
Many run p13 (new fj offset) or even a 0,
On older models pre05 it very commont to see -22 and -44 offset (I run -22 on 285/76r16)
Also if you are running 285/75r16 on 16x7p30 right now and want to got 1" wider in stance
You could look at 305/70r16 on 16x9 p20 but you'll need a lot of trimming
As a 1" wider tyre is 12.7mm a side so you are out 12.7mm already then -10mm offset gives you 1" wider stance and 1" wider wheels leaving the same inside measurment
But in all honesty you'll be much better off sticking with 285 on a p15 to p20 16x8 steel rim and running a set of lockers
farting is alot like jxxxxxg off. both provide instant gratification, but neither is a long term solution to the actual problem......................