Page 1 of 1
Number 2 Big end bearing fail 2009
Posted:
Fri, 03 Apr 2020 3:42 +0000by lux4x4
Hi all
A while since I’ve been on here.
When driving home recently my motor started to clunk, after I checked the dipstick- I then had it towed. Now the motors out & it’s dropped no.2 big end bearing.
Is this happened to anyone else?
Re: Number 2 Big end bearing fail 2009
Posted:
Fri, 03 Apr 2020 4:43 +0000by hiluxxury
Sorry to hear that mate.
Its rare but it can happen to any engine. Pradopoint has a couple of 1kd example, might be a couple here as well.
Whats your plan for getting it fixed?
Re: Number 2 Big end bearing fail 2009
Posted:
Sat, 04 Apr 2020 1:34 +0000by lux4x4
Not that rare- I’ve heard of this happening to 4 or five other owners, some with a lot less km’s than the 330 that I’ve done.
Services have always been done on time.
The motor is now out and the crank will be assessed- I’ll take it from there.
Re: Number 2 Big end bearing fail 2009
Posted:
Sat, 04 Apr 2020 6:16 +0000by Gipsy
Check the oil pickup strainer in the sump if it is clogged insufficient oil gets through to the bearing and bang! If it's clogged you have leaky injector seals, common on early 1k.
Re: Number 2 Big end bearing fail 2009
Posted:
Sat, 04 Apr 2020 4:52 +0000by lux4x4
Thanks
I’ll make sure it is cleared
Re: Number 2 Big end bearing fail 2009
Posted:
Sun, 05 Apr 2020 6:02 +0000by Gipsy
No cleaning it doesn't solve the problem. It is a symptom of leaky injector seals.